Trumouse Pro: Power Supply and Electrical Specifications
External Power Inputs
Section titled “External Power Inputs”Table: External power inputs
| Component | Input | Connector | Power source |
|---|---|---|---|
| Reader Array (RFID floor platform) | DC 5 V | DC connector, 2 per block | External low-ripple DC supply |
| Industrial Camera | External DC 12 V or 24 V | 6-pin P7 connector | External DC supply |
| Infrared Light | DC 12 ~ 24 V | DC connector | External DC supply |
| Environmental Sensor | DC 12 V or 24 V | DC connector | External DC supply |
| Switch | As specified by its manufacturer | Mains plug | Independent power supply |
| Compute Unit | As specified by its manufacturer | Mains plug | Independent power supply |
The Reader Array must be powered from a low-ripple DC supply. All external power supplies and the switch are certified commercial products. See Figure “Trumouse Pro interface locations (viewed from the right rear)” for the location of the power connectors.
Power Supply of Each Part
Section titled “Power Supply of Each Part”The Reader Array (RFID floor platform) is powered at 5 V DC. The Industrial Camera, environmental sensor and Infrared Lights support 12 V or 24 V DC power. The Compute Unit has its own power supply. All DC supplies in the system are 24 V or lower.
System Power Consumption
Section titled “System Power Consumption”Table: Estimated power consumption
| Subsystem | Power supply | Estimated power (W) |
|---|---|---|
| Reader Array (RFID floor platform) | 5 V DC | 100 |
| Infrared Lights | 12 V or 24 V DC | 100 |
| Industrial Camera | 12 V or 24 V DC | 3.2 |
| Environmental Sensor | 12 V or 24 V DC | 5 |
| Total (excluding the Compute Unit) | 208.2 |
The power figures are estimates and exclude the Compute Unit. The Industrial Camera uses the typical power consumption from its datasheet, the Infrared Lights are counted at their rated power, and the environmental sensor figure is approximate.